ExcelPTZ PTZ605 series Bedienerhandbuch PDF herunterladen (Seite 26)

Now exit the menu by moving the Joystick down, selecting EXIT and then moving the Joystick to

the right to return to the Main Menu. Again use the Joystick to select EXIT and exit the Advanced

Menu System by selecting the right pan movement.

Calling the Patrol (Tour)

There are two methods of initiating the patrol or tour. If you enter <CALL> 91 <Enter> via the

keypad you can initiate patrol/tour sequence 1

o nly.

You may also initiate a patrol or tour through the Advanced Menu System.

Enter <CALL> 95 <Enter> or <CALL> 64 <Enter> on the keypad. Enter the password to enter

the menu.

The Default password is 111111. See Advance Setup menu to change.

You will then see the Main Menu displayed on the screen.

Using the joystick up/down direction movement, select the MOTION SETUP menu.

Use the joystick pan right movement to enter this menu.

Now use the Joystick up/down direction movement to select PATROLS. To the right of this, is the

patrol sequence number (xx). By moving the Joystick to the right this number can be increased from

1 ~ 6 (up to six patrols/tours can be programmed) or decreased using the left direction movement.

Now select RUN PATROL button to initiate the patrol/tour sequence number.

Special Note: If you notice that some expected presets are not being incorporated in a patrol/tour,

check that the PATROL table has been setup correctly and shows all presets for the required

sequence. A full explanation of the values to be set can be found in the previous section Setting the

Patrol (Tour).

TIP - To stop the PATROL just move the joystick slightly.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 57 58

Keine Kommentare

ExcelPTZ PTZ605 series Bedienerhandbuch Seite 26