ExcelPTZ PTZ605 series Bedienerhandbuch PDF herunterladen (Seite 18)

If you’re using more than one dome on a site

Each dome has a unique “address” so that if you are using more than one on a site the keyboard “talks” to the

right dome when you want it to PTZ. If you only have the one dome on the site then the default “address” of

“1” is okay and you have no reason to change the dome from this.

With multiple dome sites you need to set up

each dome address separately. The following

diagram shows the switch options. SW2

sets up the protocol. This switch is dealt with

later in these instructions.

For most System Q equipment they should always be set to PELCO-D 2400 baud rate. In the diagram this is

correct. The Jumper on the far right either enables or disables the 120ohm resistor.

Setting up a unique ADDRESS in

a dome –

SW1 is used to set address of the dome camera

from 1 – 1023.

To set the dome address at 1 put switch 1 up.

To set the dome at address 2 put switch 2 up

To set the dome at address 3 put switches 1

and 2 up.

..and so on..

The following table indicates how this is done.

Speed Dome Addr ess=1

123456

7 8 9 10

Speed Dome Addr ess=2

123456

7 8 9 10

Speed Dome Addr ess=3

123456

7 8 9 10

Speed Dome Addr ess=4

1234567 8 9 10

Speed Dome Addr ess=18

1234567 8 9 10

Speed Dome Addr ess=1023

12345 67 8 9 10

Special Note:

The jumper and dipswitche

s are located on the top of

the dome head. To access them push the dome module

up and twist to release and you will see the switches as

per diagram below.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 57 58

Keine Kommentare

ExcelPTZ PTZ605 series Bedienerhandbuch Seite 18